Earlier this week I shared these simple drop cloth shades
and promised a little more info on how to make them yourself.
These have a simple, basic construction and are fairly easy to make.
Here’s what you need
Ready made ring tape (for shades)
Ribbon in your choice of color and size
(as well as scissors, sewing machine or no sew iron tape, safety pins and a tape measure)
These are fixed shades
meaning there are no cords or mechanisms for pulling them up and down.
They are just made to stay at the height that you set them and if you want to adjust them-
you do it manually adjusting the rings on the back.
To get started-
I recommend you wash your drop cloth simply to make it a little less structured
and get some of those folded wrinkles out- then it’s time to start measuring.
You want to make sure you get a good measurement of your window area.
I chose to hang my shades on the inside of the frame so I measured the inside of my window frame for the width and the length to get the correct size. (Remember to allow a little extra for sewing the edges)
Too big they will be squished inside- not good.
Too small- they will allow too much light on the sides and look short- not good either.
So measure twice- cut once. 😉
(courtesy of bedroom blackout)
Finish each side edge
After you have cut the drop cloth to the correct size you will want to finish
the side edges (lengths)
of the shade by folding them over and sewing a simple straight line
(or use no sew iron tape if you prefer)
For finishing the top and bottom of the shade-
I used the already hemmed edge of the dropcloth for the bottom of the shade
but needed a small rod pocket on the top for hanging them
so I folded the top fabric over sewed a straight line with a 2″ opening
for the tension rod in the top.
Add the ring tape for adjusting height
Then it was time for the ring tape.
This is something I found at the craft store-
It comes in a roll with rings pre-attached-
all you have to do is cut it to length and sew it onto your shade.
Note: You will need 2 lengths of ring tape for each shade.
Start at the top- about 5-6″ inside from the edge of your shade
and just under the rod pocket
and sew the tape on all the way to the bottom of the shade
Repeat on the other side so that you have 2 pieces of ring tape attached to your shade.
Adjust the drop of the shades
You can place the tension rod in the top of the shade and set it up on the window
to be able to adjust the length properly or simply adjust while it’s laying down
whatever is easiest for you.
Using an open plastic ring (some come with the tape) or a piece of wire to loop through each hole
you can adjust the length of the shade and how much it drops down and covers the window.
Honestly, I like to use something simple like a safety pin- since it closes and stays closed because
I have had problems with the open plastic rings popping open when they get too many together to hold.
Create the folds at the bottom of the shade while gathering the rings in the back
Starting at the bottom of the shade
fold the shade neatly as you gather each loop together on both sides
until you get the length you desire for the shade.
If you don’t like how the folds come out or you need to make changes
simply release the rings on the back and start over.
It took me a couple of times adjusting them to get just the look I wanted
and since drop cloth is a canvas material – it does not drape in a relaxed way-
It will be a bit more structured to work with- just take your time.
For the finishing touch~
I chose to use a wide brown grosgrain ribbon to accent the shades but you can use whatever you like
Take the ribbon and simply loop it over the top of the shade
and line it up pretty much right over where the loop ring tape is attached on the back side
Finish the ribbon with a bow or simple knot underneath
and you are done!
It really is so easy to make these
with minimal sewing or none at all if using the no sew tape.
Happy weekend everyone!